vv5更换火花塞教程，请问vv5多少公里换火花塞？

vv5更换火花塞教程

1、打开发动机舱盖，由于长城vv5发动机舱大部分位置由装饰罩掩盖，因此首先先拆下装饰罩，需要注意的是，装饰罩由卡扣固定，尽量不要用蛮力损坏这个罩子。

2、拿开罩子后的样子，中间并排的4个东西就是火花塞接线头了。

3、上面看到每个点火器都有一个固定螺丝固定住的。换火花塞就要先把上面的固定螺丝卸下来。要一个一个卸，卸完换好再去弄第二个。

4、卸下那个固定螺丝后我们就可以把点火器拉出来，这个就是连接火花塞的链接器。

5、下面把火花塞套筒套进去，然后就可以把火花塞反时针方向拧出来，第一次可能会有点紧。

6、把新火花塞套进套筒，然后顺着那个孔慢慢放进去。然后顺时针方向把他拧紧，记得拧紧后再轻轻的拧动5分之2圈就差不多啦，切勿拧太紧。安装完一个后其他剩下的三个也用以上方法弄即可。

【英文介绍/For English】：

1. Open the engine compartment cover. Since most of the engine compartment of the Great Wall vv5 is covered by the decorative cover, first remove the decorative cover. It should be noted that the decorative cover is fixed by the buckle, try not to damage the cover with brute force.

2. After removing the cover, the 4 things side by side in the middle are the spark plug terminals.

3. As seen above, each igniter has a fixing screw to fix it. To replace the spark plug, first remove the set screw on it. You have to unload one by one, and then you can get the second one after unloading and replacing.

4. After removing the fixing screw, we can pull out the igniter. This is the linker that connects the spark plug.

5. Put the spark plug sleeve in below, and then unscrew the spark plug counterclockwise. It may be a little tight for the first time.

6. Put the new spark plug into the sleeve, and then slowly put it in along the hole. Then tighten it in a clockwise direction. Remember to tighten it and then gently twist it for two-fifths of a turn. Don't tighten it too much. After installing one, you can use the above method for the remaining three.

vv5多少公里换火花塞

1. 准备工作 首先，需要准备一把扳手和一只火花塞钳，还需要准备一款合适的新火花塞。同时关掉所有电器和引擎，待摩托车冷却后再进行更换。

2. 拆卸旧火花塞

在使用火花塞钳之前，需要先从摩托车上去除原有的火花塞。使用扳手松开火花塞摇臂盖，然后再用火花塞钳紧握火花塞，逆时针旋转并将其从摩托车中移除。请注意，在移除旧火花塞时，要避免扭曲或损坏火花线。

3. 清洁线路 在插入新火花塞之前，需要确保插座和线路清洁无油和灰尘。可以使用空气喷雾器或者布擦洗处理。

4. 安装新火花塞 拧回新火花塞，将其插入插座并使用手指旋转数次以确保确实紧密插入。请注意，不要使火花塞过度插入插座。

5. 调整火花塞 使用扳手适当调整火花塞摇臂盖，通常需要进行轻微的调整。将摩托车上所有部件安装回原位，重新启动电器和引擎。 至此，摩托车火花塞更换完成。