奔驰glc定速巡航怎么关？请问奔驰定速巡航怎么用？

奔驰glc定速巡航怎么关

拨杆有四个方向，分别是前后上下，往上提恢复刚刚速度，往下按巡航关闭，往前轻拨，速度提升一迈，往前到底速度提升十迈，往后轻拨速度降一迈，往后拨到底速度降十迈。

奔驰GLC使用定速巡航注意事项如下：

①定速巡航需车主自己踩刹车，而自适应能自动制动。但是电子设备难免会有不灵敏的地方，驾驶员还是要时刻注意周遭的情况。

②一旦踩下制动踏板，定速巡航就结束了。设置的速度值依然保留，通过手动方式可以恢复巡航。

③道路蜿蜒陡峭、颠簸湿滑，以及车辆较多等情况下，使用定速巡航容易造成危险。务必关闭掉定速巡航，以免造成危险。

④在下陡坡时，车辆在重力作用下会溜得更快。此时脚踩刹车，或者关闭巡航功能。

【英文介绍/For English】：

The lever has four directions, namely, front and rear, up and down, lift it up to restore the speed just now, press down to turn off the cruise, push it forward to increase the speed by one step, move forward to the end and increase the speed by ten steps, and push it backward to decrease the speed by one step. Step, dial back to the end and the speed drops ten steps.

The precautions for using cruise control in Mercedes-Benz GLC are as follows:

①The cruise control requires the car owner to step on the brakes, while the adaptive can automatically brake. However, electronic equipment will inevitably have insensitive places, and the driver should always pay attention to the surrounding situation.

②As soon as the brake pedal is depressed, the cruise control is over. The set speed value is still retained, and cruise can be resumed manually.

③When the road is winding and steep, bumpy and slippery, and there are many vehicles, the use of cruise control is likely to cause danger. Be sure to turn off the cruise control to avoid danger.

④ When going down a steep slope, the vehicle will slide faster under the action of gravity. At this time, step on the brake, or turn off the cruise function.

奔驰定速巡航怎么用

1.目前大部分定速巡航系统的使用方法如下：按on键开启系统，仪表盘上的定速巡航指示灯亮起。2.加速到你需要的速度，按下SET键，然后你的右脚就可以松开油门，速度就设定为当前速度。3.按“res”以当前速度增加速度，按“set-”以当前速度降低速度。4.取消巡航控制有三种方式：踩刹车，按取消键，按\/键。5.如果您按下刹车或取消键取消巡航，您可以按下RES键返回到以前的巡航速度。